However, I didn’t have time to check if there are issues regarding specific versions of that model of card needing a module other than tulip. Visit the following links: Please do not send me a PM asking for help Do you need to compile it first, or just install it? The tulip driver has been built into the kernel for a looooong time.

Uploader: Kazraran
Date Added: 15 December 2010
File Size: 54.3 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 99610
Price: Free* [*Free Regsitration Required]

Setting up 3Com 3csoho100-TX nic

Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter. Having trouble installing a piece of hardware?

Linux – Hardware This forum is for Hardware issues. The above message is telling you what to look at for more information about the probable cause, and the second link I gave you in my last post gives specific troubleshooting steps for exactly this problem.

If you see this message at boot time and the driver fails to attach the device as a network interface, you will have to perform second warm boot to have the 3csoh1o00b properly configured. Fast Etherlink XL adapters such as the 3cTX and 3cB-TX are capable of 10 or Mbps data rates in either full or half duplex and can be manually configured for any supported mode or automatically negotiate the highest possible mode with a link partner. HTH Knute You live, you die, enjoy the interval!


Note 3csoo100b registered members see fewer ads, and ContentLink is completely disabled once you log in. Want to know if that peripheral is compatible with Linux? I’ll be back in a bit.

Click Here to receive this Complete Guide absolutely free.

– Bad: 3CSOHOB-TX network card not recognized

This message may be printed during driver initialization on slower machines. The xl driver supports the following media types: Neither the xl driver nor any other FreeBSD driver supports this modem. The time now is All times are GMT So you have two ethernet cards?

Originally posted by mdwatts Have we established what nic model you have that is supposed to be using the tulip module? This compensation may impact how and where products appear on this site including, for example, the order in which they appear. Do you need to compile it first, or just install it? Read thisand more specifically this for more information and help. You shouldn’t have to compile it from source; you probably have other problems with the NIC setup.

QuinStreet does not include all companies or all types of products available in the marketplace.


If “modprobe tulip” doesn’t work, run the 3vsoho100b command and then try the modprobe again: If you need to reset your password, click here.

Some operating systems place the 3cB in low power mode when shutting down, and some PCI BIOSes fail to bring the chip out of this state before configuring it. This warning may appear when using the driver on some Dell Latitude docking stations with built-in 3cTX adapters. If so, please post the complete and accurate results of working through those troubleshooting steps.

What kind of troubles are you having with it? Please read the search suggestion thread in JL Ideas.

CONFIG_TULIP: DECchip Tulip (dc2114x) PCI support

Join our community today! Having a problem logging in? Have we established what nic model you have that is supposed to be using the tulip module?

Knute You live, you die, enjoy the interval! Please visit this page to clear all LQ-related cookies. Have you tried any of the troubleshooting tips DMR posted?